IV. INSPECTION – MEASUREMENT r n i engine

IV. INSPECTION – MEASUREMENT

1. Universal joint (drive shaft)
Visual check: Crack, grease lubricating, spline condition, chipping
Manual check Torque bolt
Measuring Bending, Twisting
2. Rubber mounting
Visual check: Crack, chipping
Manual check Elastisitas
Measuring Free high rubber mounting.
3. V- belt & Fan belt
Visual check Crack, chipping
Measuring Belt tension, alignment (kelurusan belt)
4. Level sensor (switch)
Visual check : Cable & connector conditions
Measuring : Connectivitas (Max.1 atau Min. 1M)
5. Temperatur & Pressure sensor (lihat standart di shop manual)
Visual check : Cable & connector conditions
Measuring : Resistance ()
6. Radiator
Visual check : Water, oil leakage, clogged (fin), cleanness
Measuring : Radiator pressure, temperature, clogeed fin with anemometer
7. Fan guard
Visual check. Penyok, bolt & nut mounting
8. Pedal accelerator
Visual check Grease lubricating
Measurement Operating force, Play of pedal, Resistance value,
Idling Validation Switch - Connectivitas (Max.1 atau Min.1M)
9. Alignment
Visual check Center fan alignment
Measuring Drive shaft alignment